- +91 9442461708
- huzefa74@gmail.com
Hydraulic Fittings
- Home
- Hydraulic Fittings
Source hydraulic fittings in Chennai through Indian Hydraulics & Pneumatics for industrial tube and hose connections. Share the tube dimensions, thread standard, sealing face, material, operating pressure and fitting geometry. Compare the ferrule and Ermeto options below, or send part markings and photographs for replacement-matching support before requesting a quotation.
Hydraulic pipe fittings connect tubes, hoses, ports and manifolds while containing the system medium. Selection depends on the connection standard, thread, tube size, pressure, material, sealing method and assembly procedure.
For a replacement, send the tube outside diameter and wall thickness, port thread, sealing face, fitting geometry and any original part marking. A nominal thread size alone does not identify the seal.
| Connection system | Metric tube connection with a 24° cutting-ring interface. |
|---|---|
| Standards reference | Parker identifies ISO 8434, DIN 2353 and DIN 3861 for this system. |
| Sealing method | EO-2 uses an elastomeric tube-side seal; the retaining ring provides mechanical retention. |
| Assembly check | The gap between the retaining ring and sealing ring is checked for closure in Parker’s assembly procedure. |
Source: Parker EO-2 technical brochure (PDF). These details describe EO-2, not every single-bite or double-bite fitting in our catalogue. Confirm the requested variant, tube specification, material and rated limits with IHPC before ordering.
For connected line components, review hydraulic hoses and Holmbury hydraulic ball valves. For compressed-air push-in connections, use the separate one-touch fittings range.
For a replacement, follow our hydraulic fitting identification guide to record the thread, sealing face, tube size and part markings.
Selection note: Do not identify a fitting by appearance alone. Confirm thread standard, size, sealing face, material and pressure requirement.
Representative single-bite, double-bite and Ermeto fitting products are shown below.
Single-bite ferrule fitting range for matched tube connection requirements.
Double-bite ferrule fitting option from the current IHPC catalogue.
Ermeto fitting family for buyers matching established fluid connection systems.
A fitting joins fluid-power components through a defined thread, sealing face, ferrule or flange arrangement. Correct assembly develops the intended seal without damaging the tube or connection.
The fitting family, material and assembly method must follow the current manufacturer instructions.
Identify thread, flange or ferrule system accurately.
Confirm outside diameter, bore and matching end.
Check material, seal and current rated limits.
Use the specified preparation and tightening procedure.
Final suitability depends on the complete application and the current manufacturer technical data.
Connections around pumps, valves, manifolds and tanks.
Tube and hose connections on production equipment.
Compact tube fittings for measurement and control.
Matching damaged or obsolete connections from samples.
Check thread diameter and pitch, sealing face, connection standard, tube or hose size and material. A sample or clear drawing helps.
IHPC supplies hydraulic and instrumentation fittings from Chennai. Contact the team with your connection details before visiting or ordering.
Some connection styles look similar, but pressure, seal, material and intended medium can differ. Use a fitting approved for the circuit.
Provide quantity, size, thread or standard, material, pressure, medium and a photo or drawing where possible.
Send your application details to IHPC for product matching, current availability and a quotation.
